We report the DFT study of the vibrational spectroscopy properties of Mg(B₃H₈)₂, a potential intermediate in the decomposition of Mg(BH₄)₂, as well as those of CB₁₁H₁₂^− and CB₉H₁₀^−, whose salts can exhibit high ionic conductivities. Because the inclusion of anharmonicity is key to the accurate description of the vibrational properties of BH species [D. Sethio, L. M. Lawson Daku, H. Hagemann. Int. J. Hydrogen Energy, 41 (2016) 6814], the calculations were performed both in the harmonic and in the anharmonic approximation. The IR and Raman spectra of Cs(CB₁₁H₁₂) and Na₂(B₁₀H₁₀) have also been measured. The calculated and experimental spectra are in good agreement. A comparative analysis of the vibrational spectroscopy properties is made for B₃H₈^− and Mg(B₃H₈)₂, B₁₂H₁₂^2− and CB₁₁H₁₂^−, and for B₁₀H₁₀^2− and CB₉H₁₀^−.

Borohydrides have attained high interest in the past few years due to their high volumetric and gravimetric hydrogen content. Synthesis of di/trimetallic borohydride is a way to alter the thermodynamics of hydrogen release from borohydrides. Previously reported preparations of M(BH₄)₂ involved chloride containing species such as SrCl₂. The presence of residual chloride (or other halide) ions in borohydrides may change their thermodynamic behavior and their decomposition pathway. Pure monometallic borohydrides are needed to study decomposition products without interference from halide impurities. They can also be used as precursors for synthesizing di/trimetallic borohydrides. In this paper we present a way to synthesize halide free alkaline earth metal (Sr, Ba) and europium borohydrides starting with the respective hydrides as precursors. Two novel high temperature polymorphs of Sr and Eu borohydrides and four polymorphs of Ba borohydride have been characterized by synchrotron X-ray powder diffraction, thermal analysis, and Raman and infrared spectroscopy and supported by periodic DFT calculations. The decomposition routes of these borohydrides have also been investigated. In the case of the decomposition of strontium and europium borohydrides, the metal borohydride hydride (M(BH₄)H₃, M = Sr, Eu) is observed and characterized. Periodic DFT calculations performed on room temperature Ba(BH₄)₂ revealed the presence of bidentate and tridentate borohydrides.

The characterization of boron-hydrogen compounds is an active research area which encompasses subjects as diverse as the chemistry and structures of closoboranes or the thermal decomposition mechanism of the borohydrides. Due to their high gravimetric hydrogen content, borohydrides are considered as potential hydrogen storage materials. Their thermal decompositions are multistep processes, for which the intermediate products are not easily identified. To help address this issue, we have extensively investigated the vibrational and NMR properties of 21 relevant B_mHnz− boron-hydrogen species (m = 1–12; n = 1–14; z = 0–2) within density functional theory. We could thus show that the B3LYP-D2 dispersion-corrected hybrid can be used in combination with the large cc-pVTZ basis set for the reliable prediction of the ¹¹B and ¹H NMR spectra of the boron-hydrogen species, and also for the reliable prediction of their IR and Raman spectra while taking into account the anharmonicity of their molecular vibrations.

Among the different potential hydrogen storage materials, borohydrides have been largely investigated because of their high gravimetric and volumetric hydrogen content. In the analysis of borohydrides, vibrational spectroscopy plays an important role since it gives information on the local structure of the BH₄^– ion inside the solid. Here the GF method, developed by Wilson, is used in order to determine the local symmetry of BH₄^– in solid borohydrides starting from their vibrational spectra. Two different cases of deformations of BH₄^– are considered. In the first case, the effects of small angular variations on the vibrational spectra of borohydrides will be taken into account; starting from the splitting of the bands corresponding to the deformation modes, the angular deformations will be estimated. In the second one, the BH₄^– under chemical pressure (in different cubic alkali halides) is considered; in this case, the symmetry of the BH₄^– remains T_d, while the bond lengths change according to the pressure experienced. Different practical examples will be illustrated.

A comparison of the vibrational spectra of many inorganic borohydrides allows us to distinguish compounds with isolated BH₄^- ions and compounds containing complex ions such as Sc(BH₄)₄^-. The characteristic spectral features of both types of compounds are identified, showing that the B–H bonding is quite different in both cases. A detailed analysis of the vibrations of the isolated BH₄^- ions provides new information about their local structure. Angular deformations of individual borohydride ion are analyzed quantitatively. It appears that the compounds containing isolated BH₄^- ions belong to those with the most electropositive cations and the highest decomposition temperature, while the complex borohydrides show significantly lower decomposition temperatures and possible diborane formation.

Four novel bimetallic borohydrides have been discovered, K₂M(BH₄)₄ (M = Mg or Mn), K₃Mg(BH₄)₅, and KMn(BH₄)₃, and are carefully investigated structurally as well as regarding their decomposition reaction mechanism by means of in situ synchrotron radiation powder X-ray diffraction (SR-PXD), vibrational spectroscopies (Raman and IR), thermal analysis (TGA and DTA), and ab initio density functional theory (DFT) calculations. Mechano-chemical synthesis (ball-milling) using the reactants KBH₄, α-Mg(BH₄)₂, and α-Mn(BH₄)₂ ensures chlorine-free reaction products. A detailed structural analysis reveals significant similarities as well as surprising differences among the two isomorphs K₂M(BH₄)₄, most importantly concerning the extent to which the complex anion [M(BH₄)₄]^2– is isolated in the structure. Anisotropic thermal expansion and an increase in symmetry at high temperatures in K₃Mg(BH₄)₅ is ascribed to the motion of BH₄ groups inducing hydrogen repulsive effects, and the dynamics of K₃Mg(BH₄)₅ are investigated. Decomposition in the manganese system proceeds via the formation of KMn(BH₄)₃, the first perovkite type borohydride reported to date.

The crystal chemistry of the barium fluoride chloride system is studied both experimentally and theoretically. Different synthetic approaches yield nanocrystalline materials as well as large single crystals. The crystalline phases identified so far are BaFCl, Ba₁₂F₁₉Cl₅ and Ba₇F₁₂Cl₂ (in two modifications) and compared with analogous compounds. It is demonstrated that the compound Ba₂F₃Cl reported by Fessenden and Lewin 50 years ago corresponds to Ba₇F₁₂Cl₂. The phase diagram of the BaCl₂ – BaF₂ system is reinvestigated for fluoride mole fractions between 0.5 and 1. The peritectic formation of Ba₁₂F₁₉Cl₅ is observed. Periodic DFT calculations are performed for all structures in this system, including a hypothetical structure for Ba₂F₃Cl, based on the experimental structure of Ba₂H₃Cl. The energy of formation of the different barium fluoride chloride compounds from BaCl₂ and BaF₂ (normalized for one barium atom per formula unit), as calculated by DFT at 0K, is within only about ± 15 kJ/mol. Comparison with recent experimental results on calcium and strontium hydride chloride (bromide) compounds, suggest the possibility of a mutual exclusion between the M₂X₃Y and M₇X₁₂Y₂ (M = Ca, Sr, Ba, Pb, X = H, F, Y = Cl,Br) structures. The single crystal structure of PbFBr is also reported.

The structural and vibrational properties of the isostructural compounds Ca₂FeH₆ and Sr₂RuH₆ are determined by periodic DFT calculations and compared with their previously published experimental crystal structures as well as new experimental vibrational data. The analysis of the vibrational data is extended to the whole series of alkaline-earth iron and ruthenium hydrides A₂TH₆ (A = Mg,Ca,Sr; T = Fe, Ru) in order to identify correlations between selected frequencies and the T-H bond length. The bulk moduli of Ca₂FeH₆ and Sr₂RuH₆ have also been determined within DFT. Their calculated values prove to compare well with the experimental values reported for Mg₂FeH₆ and several other compounds of this structure.

The effect on crystal structure and vibrational frequencies of physical pressure in BaFCl and chemical pressure in Ba_1−xSr_xFCl solid solutions is studied using periodic density-functional theory (DFT) calculations performed within the local-density approximation (LDA) and the generalized gradient approximation (GGA). These results are compared with previously published experimental data for BaFCl in conjunction with new experimental data for Ba_1−xSr_xFCl and show overall a good agreement with experiment. The GGA method outperforms the LDA method for the description of BaFCl under pressure. However, the two DFT methods perform equally well for the description of the solid solutions, which have been studied within the virtual-crystal approximation. They also give consistent values of the energy of formation of Ba_1−xSr_xFCl, which can be correlated with the experimentally observed melting points. The comparison of the calculated mode Grüneisen parameters shows that, for the investigated systems, the effect of the chemical pressure and that of the physical pressure are not identical.

The new double-cation Al-Li-borohydride is an attractive candidate material for hydrogen storage due to a very low hydrogen desorption temperature (~70 °C) combined with a high hydrogen density (17.2 wt %). It was synthesised by high-energy ball milling of AlCl₃ and LiBH₄. The structure of the compound was determined from image-plate synchrotron powder diffraction supported by DFT calculations. The material shows a unique 3D framework structure within the borohydrides (space group=P-43n, a=11.3640(3) Å). The unexpected composition Al₃Li₄(BH₄)₁₃ can be rationalized on the basis of a complex cation [(BH₄)Li₄]³⁺ and a complex anion [Al(BH₄)₄]^-. The refinements from synchrotron powder diffraction of different samples revealed the presence of limited amounts of chloride ions replacing the borohydride on one site. In situ Raman spectroscopy, differential scanning calorimetry (DSC), thermogravimetry (TG) and thermal desorption measurements were used to study the decomposition pathway of the compound. Al-Li-borohydride decomposes at ~70 °C, forming LiBH₄. The high mass loss of about 20 % during the decomposition indicates the release of not only hydrogen but also diborane.

The influence of pressure on the structural and vibrational properties of a₂RuH₆has been investigated using periodic density functional theory calculations performed at the local density approximation (LDA) and generalized gradient approximation (GGA) levels. At ambient pressure, the calculated structure and vibrational frequencies are in satisfactory agreement with experimental data. The calculated em>P-Vcurves could be fitted with the Vinet equation of state, yielding em>B₀=67.6and em>B₀=58.5  GPaat the LDA and GGA levels, respectively, and em>B₀^′=4.0at both theoretical levels. The unit cell parameter is found to decrease faster with increasing pressure than the Ru–H bond length. The calculated pressure dependence of the vibrational frequencies agrees well with experiment for em>ν₅(T_2g)but not for em>ν₉(A_1g)